...
Integrating the CODESYS device in the ETS
- The controller can be added to the ETS project by means of the catalog.
Assign a physical address to the device: - On the DCA tab, the configuration previously exported in CODESYS can be read into the ETS.
- After the import, the inputs and outputs created in CODESYS can be connected with group addresses.
Transferring the ETS configuration to the controller
- As with any other device, the physical address must also be assigned to the CODESYS controller.
Therefore the data point must be set after the request in the ETS:
If this is done promptly, then the assignment of the physical address is documented in the ETS.
Because the controller does not have a valid program yet, it must still be downloaded from the ETS.
Likewise, the actuator (channel B) can be switched by means of I/O mapping. - fd.
- d.
- d.d.
- d.
- d.
- d.
- d.